Filter
Top Products
Reference for the Accelar 8000 Series Command Line Interface Routing Operations
8-18 208967-A
Figure 8-9 shows an example of the config ip traffic-filter
traffic-profile info
Passport-8610:5# config ip traffic-filter traffic-profile 1 info
Sub-Context: clear config dump monitor show test trace
Current Context:
name : test
enable : true
translate-dscp : disable
in-dscp : 000000
out-dscp : 000000
discard-out-profile : enable
average-rate : 0
Figure 8-9.
config ip traffic-filter traffic-profile info
Command Output
config ethernet <ports> ip traffic-filter Commands
The config ethernet <ports> ip traffic-filter commands allow you to
set filters at the port level to manage traffic. Each filter set includes match
conditions and actions to be performed when a match condition is satisfied. These
commands include <ports> as the port list {slot/port[-slot/port][,...]}.
config ethernet <ports> ip traffic-filter
followed by:
info Displays the traffic filters applied to the port.
add set <value> Adds a set filter to a port.
• set <value> is the global or source/destination
filter set ID (1 to 1000).
create Creates a traffic filtering entity on a port.
default-action forward Sets the port filter default action to forward.
default-action drop Sets the port filter default action to drop.
default-action info Displays the port default action configuration.
default-action none Does not apply any policy to filtered ports.
delete Removes filtering from a port.
cli.book Page18 Wednesday, April 19,2000 3:14 PM