![](http://pdfasset.owneriq.net/3/88/3884ec60-08cc-bac4-b176-2f6590d63c88/3884ec60-08cc-bac4-b176-2f6590d63c88-bg431.png)
Routing Protocol Configuration Command Set
Configuring RIP
Matrix NSA Series Configuration Guide 13-21
13.2.2.14 ip rip authentication keychain
Use this command to enable or disable a RIP authentication key chain for use on an interface.
ip rip authentication keychain name
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command prevents RIP from using authentication:
no ip rip authentication keychain name
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Examples
This example shows how to set the RIP authentication key chain to “password” on VLAN 1:
NOTE: A RIP authentication keychain must be enabled with this command before the
RIP authentication mode (Section 13.2.2.15) can be configured.
name Specifies the key chain name to enable or disable for RIP
authentication.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip rip authentication keychain password