Filter
Top Products
Routing Protocol Configuration Command Set
Configuring OSPF
Matrix NSA Series Configuration Guide 13-67
Table 13-4 show ip ospf interface Output Details
Output What It Displays...
Vlan Interface (VLAN) administrative status as up or down.
Internet Address IP address and mask assigned to this interface.
Router ID Router ID, which OSPF selects from IP addresses
configured on this router.
Network Type OSPF network type, for instance, broadcast.
Cost OSPF interface cost, which is either default, or assigned
with the ip ospf cost command. For details, refer to
Section 13.2.3.4.
Transmit Delay The number (in seconds) added to the LSA (Link State
Advertisement) age field.
State The interface state (versus the state between neighbors).
Valid values include BACKUPDR (Backup Designated
Router), and DR (Designated Router).
Priority The interface priority value, which is either default, or
assigned with the ip ospf priority command. For details,
refer to Section 13.2.3.5.
Designated Router
id
The router ID of the designated router on this subnet, if one
exists.
Interface addr IP address of the designated router on this interface.
Backup Designated
Router id
IP address of the backup designated router on this interface,
if one exists.
Timer intervals
configured
OSPF timer intervals. These are either default, or configured
with the ip ospf retransmit-interval (Section 13.2.3.7), the
ip ospf hello-interval (Section 13.2.3.9), and the ip ospf
dead interval (Section 13.2.3.10) commands. The wait
timer represents the amount of time a router waits before
initiating a designated router/backup designated router
election. The wait timer changes when the dead interval
changes. The retransmit timer represents the amount of time
between successive transmissions of LSAs (Link State
Advertisements) until acknowledgement is received.
Neighbor Count Number of neighbors over this interface.