General Configuration Command Set
Starting and Configuring Telnet
2-100 Matrix NSA Series Configuration Guide
2.2.7 Starting and Configuring Telnet
Purpose
To enable or disable Telnet, and to start a Telnet session to a remote host. The Matrix Series device
allows a total of four inbound and / or outbound Telnet session to run simultaneously.
Commands
The commands used to enable, start and configure Telnet are listed below and described in the
associated section as shown.
• show telnet (Section 2.2.7.1)
• set telnet (Section 2.2.7.2)
• telnet (Section 2.2.7.3)
• show router telnet (Section 2.2.7.4)
• set router telnet (Section 2.2.7.5)
• clear router telnet (Section 2.2.7.6)