Filter
Top Products
SNMP Configuration Command Set
Configuring SNMP Target Parameters
Matrix NSA Series Configuration Guide 5-43
5.3.5.2 set snmp targetparams
Use this command to set SNMP target parameters, a named set of security/authorization criteria
used to generate a message to a target.
set snmp targetparams paramsname user user security-model {v1 | v2c | usm}
message-processing {v1 | v2c | v3} [noauthentication | authentication | privacy]
[volatile | nonvolatile]
Syntax Description
Command Defaults
None.
• If not specified, security level will be set to noauthentication.
• If not specified, storage type will be set to nonvolatile.
Command Type
Switch command.
Command Mode
Read-Write.
paramsname Specifies a name identifying parameters used to generate
SNMP messages to a particular target.
user user Specifies an SNMPv1 or v2 community name or an
SNMPv3 user name. Maximum length is 32 bytes.
security-model v1 |
v2c | usm
Specifies the SNMP security model applied to this target
parameter as version 1, 2c or 3 (usm).
message-
processing v1 | v2c
| v3
Specifies the SNMP message processing model applied to
this target parameter as version 1, 2c or 3.
noauthentication |
authentication |
privacy
(Optional) Specifies the SNMP security level applied to
this target parameter as no authentication, authentication
(without privacy) or privacy. Privacy specifies that
messages sent on behalf of the user are protected from
disclosure.
volatile |
nonvolatile
(Optional) Specifies the storage type applied to this target
parameter.