Filter
Top Products
Security Configuration Command Set
Configuring RADIUS
Matrix NSA Series Configuration Guide 14-17
14.3.2.5 set radius accounting
Use this command to configure RADIUS accounting.
set radius accounting {[enable] [disable] [intervalminimum value]
[updateinterval value] [retries retries] [timeout timeout] [server {index | all}
ip_address port [server-secret]
Syntax Description
Command Type
Switch command.
enable | disable Enables or disables the RADIUS accounting client.
intervalminimum
value
Sets the minimum interval at which RADIUS accounting
will send interim updates. Valid values are 60 -
2147483647.
updateinterval
value
Sets the number of seconds between each RADIUS
accounting interim update (when accumulated accounting
data is sent to the server for a session.) Valid values are 180
- 2147483647.
retries retries Sets the maximum number of attempts to contact a
specified RADIUS accounting server before timing out.
Valid retry values are 1 - 2147483647.
timeout timeout Sets the maximum amount of time (in seconds) to establish
contact with a specified RADIUS accounting server before
timing out. Valid timeout values are 1 - 2147483647.
index | all Applies the settings to a specific RADIUS accounting
server or to all.
server ip_address
port server-secret
Specifies the accounting server’s:
• IP address
• UDP authentication port (0 - 65535)
• server-secret (Read-Write password to access this
accounting server. Device will prompt for this entry
upon creating a server instance, as shown in the example
below.)