Routing Protocol Configuration Command Set
Configuring VRRP
13-90 Matrix NSA Series Configuration Guide
13.2.6 Configuring VRRP
Purpose
To enable and configure the Virtual Router Redundancy Protocol (VRRP). This protocol eliminates
the single point of failure inherent in the static default routed environment by transferring the
responsibility from one router to another if the original router goes down. VRRP-enabled routers
decide who will become master and who will become backup in the event the master fails.
Commands
The commands used to enable and configure VRRP are listed below and described in the associated
section as shown:
• router vrrp (Section 13.2.6.1)
• create (Section 13.2.6.2)
• address (Section 13.2.6.3)
• priority (Section 13.2.6.4)
• master-icmp-reply (Section 13.2.6.5)
• advertise-interval (Section 13.2.6.6)
• critical-ip (Section 13.2.6.7)
• preempt (Section 13.2.6.8)
• preempt-delay (Section 13.2.6.9)
• enable (Section 13.2.6.10)
• ip vrrp authentication-key (Section 13.2.6.11)
• ip vrrp message-digest-key (Section 13.2.6.12)
• show ip vrrp (Section 13.2.6.13)