Routing Protocol Configuration Command Set
Configuring OSPF
Matrix NSA Series Configuration Guide 13-71
13.2.3.28 show ip ospf virtual-links
Use this command to display information about the virtual links configured on a router. A virtual
link represents a logical connection between the backbone and a non-backbone OSPF area.
show ip ospf virtual-links
Syntax Description
None.
Command Type
Router command.
Command Mode
Any router mode.
Command Defaults
None.
Example
This example shows how to display OSPF virtual links information:
Table 13-6 provides an explanation of the command output.
Matrix>Router1#show ip ospf virtual-links
Virtual Link to router 5.5.5.1, is UP
Transit area 0.0.0.2,via interface Vlan 7, Cost of using 10
Transmit Delay is 1 sec(s), State POINT-TO-POINT
Timer intervals configured:
Hello 10, Dead 40, Wait 40, Retransmit 5
Adjacency State FULL
Table 13-6 show ip ospf virtual links Output Details
Output What It Displays...
Virtual Link ID of the virtual link neighbor, and the virtual link status,
which is up or down.
Transit area ID of the transit area through which the virtual link is
configured.
via interface Router’s interface into the transit area.
Cost of using OSPF cost of routing through the virtual link.