![](http://pdfasset.owneriq.net/3/88/3884ec60-08cc-bac4-b176-2f6590d63c88/3884ec60-08cc-bac4-b176-2f6590d63c88-bg266.png)
VLAN Configuration Command Set
Enabling/Disabling GVRP
7-42 Matrix NSA Series Configuration Guide
7.3.6.5 set garp timer
Use this command to adjust the values of the join, leave, and leaveall timers.
set garp timer {[join timer-value] [leave timer-value] [leaveall timer-value]}
port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the GARP join timer value to 100 centiseconds for all ports:
This example shows how to set the leave timer value to 300 centiseconds for all ports:
NOTE: The setting of these timers is critical and should only be changed by personnel
familiar with the 802.1Q standards documentation, which is not supplied with this
device.
join timer-value Sets the GARP join timer in centiseconds (Refer to 802.1Q
standard.)
leave timer-value Sets the GARP leave timer in centiseconds (Refer to
802.1Q standard.)
leaveall
timer-value
Sets the GARP leaveall timer in centiseconds (Refer to
802.1Q standard.)
port-string Specifies the port(s) on which to configure GARP timer
settings. For a detailed description of possible port-string
values, refer to Section 4.1.1.
Matrix(rw)->set garp timer join 100 *.*.*
Matrix(rw)->set garp timer leave 300 *.*.*