Routing Protocol Configuration Command Set
Configuring VRRP
13-94 Matrix NSA Series Configuration Guide
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Examples
This example shows how to configure a virtual router address of 182.127.62.1 on VLAN 1, VRID
1, and to set the router connected to the VLAN via this interface as the master:
This example shows how to configure 5 virtual router addresses on a single interface, VLAN 1,
VRID 1. All 5 addresses fall within the range of networks configured on the VLAN 1 routing
interface, because VLAN 1 has a primary IP address of 182.127.62.1/24, and secondary IP
addresses of 10.1.1.1/24 and 10.2.2.1/24. All virtual addresses are non-owners.
Matrix>Router1(config)#router vrrp
Matrix>Router1(config-router)#address vlan 1 1 182.127.62.1 1
Matrix>Router1(config)#router vrrp
Matrix>Router1(config-router)#address vlan 1 1 182.127.62.2 0
Matrix>Router1(config-router)#address vlan 1 1 10.1.1.2 0
Matrix>Router1(config-router)#address vlan 1 1 10.1.1.3 0
Matrix>Router1(config-router)#address vlan 1 1 10.2.2.2 0
Matrix>Router1(config-router)#address vlan 1 1 10.2.2.3 0