IP Configuration Command Set
Reviewing and Configuring the ARP Table
12-26 Matrix NSA Series Configuration Guide
12.2.4.6 ip mac-address
Use this command to set a MAC address on an interface.
ip mac-address address
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command clears the MAC address:
no ip mac-address
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set an IP MAC address of 000A.000A.000B. on VLAN 1:
NOTE: By default, every routing interface uses the same MAC address. If the user
needs interfaces to use different MAC addresses, this command will allow it. It is the
user’s responsibility to select a MAC address that will not conflict with other devices on
the VLAN since the Matrix Series device will not automatically detect this conflict.
address Specifies a 48-bit MAC address in hexadecimal format.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip mac-address 000A.000A.000B