Filter
Top Products
Security Configuration Command Set
Configuring Multiple Authentication
14-134 Matrix NSA Series Configuration Guide
Purpose
To configure multiple authentication.
Commands
The commands used to configure multiple authentication are listed below and described in the
associated section as shown:
• set multiauth mode (Section 14.3.10.1)
• clear multiauth mode (Section 14.3.10.2)
• set multiauth precedence (Section 14.3.10.3)
• clear multiauth precedence (Section 14.3.10.4)
• show multiauth port (Section 14.3.10.5)
• set multiauth port (Section 14.3.10.6)
• clear multiauth port (Section 14.3.10.7)
• show multiauth station (Section 14.3.10.8)
• clear multiauth station (Section 14.3.10.9)
• show multiauth session (Section 14.3.10.10)
• show multiauth idle-timeout (Section 14.3.10.11)
• set multiauth idle-timeout (Section 14.3.10.12)
• clear multiauth idle-timeout (Section 14.3.10.13)
• show multiauth session-timeout (Section 14.3.10.14)
• set multiauth session-timeout (Section 14.3.10.15)
• clear multiauth session-timeout (Section 14.3.10.16)
NOTE: In order for multiple authentication to function on the device, each possible
method of authentication (MAC authentication, PWA, 802.1X)
must be enabled globally
and configured appropriately on the desired ports per its corresponding command set
as described in this chapter.
Multiple authentication mode must be globally enabled on the device using the set
multiauth mode command as described in Section 14.3.10.1.