Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
Matrix NSA Series Configuration Guide 4-75
4.3.8.6 set linkflap interval
Use this command to set the time interval (in seconds) for accumulating link down transitions.
set linkflap interval port-string interval_value
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the link flap interval on port fe.1.4 to 1000 seconds:
port-string Specifies the port(s) on which to set the link flap interval.
For a detailed description of possible port-string values,
refer to Section 4.1.1.
interval_value Specifies an interval in seconds. A value of 0 will set the
interval to forever.
Matrix(rw)->set linkflap interval fe.1.4 1000