Enterasys Networks N Standalone (NSA) Series Switch User Manual


  Open as PDF
of 1372
 
IP Configuration Command Set
Configuring Routing Interface Settings
Matrix NSA Series Configuration Guide 12-9
Table 12-2 provides an explanation of the command output.
Table 12-2 show ip interface Output Details
Output What It Displays...
Vlan | Lpbk | Lo N Whether the interface is administratively and operationally
up or down.
IP Address Interface’s IP address and mask. Set using the ip address
command as described in Section 12.2.1.5.
Frame Type Encapsulation type used by this interface. Set using the arp
command as described in Section 12.2.4.2.
MAC-Address MAC address mapped to this interface. Set using the ip
mac-address command as described in Section 12.2.4.6.
Incoming |
Outgoing Access
List
Whether or not an access control list (ACL) has been
configured on this interface using the commands described
in Section 14.3.12.
IP Helper Address Whether or not an IP address has been designated for
forwarding UDP datagrams from this interface. Set using the
ip helper-address command as described in
Section 12.2.5.3
MTU Interface’s Maximum Transmission Unit size.
ARP Timeout Duration for entries to stay in the ARP table before expiring.
Set using the arp timeout command as described in
Section 12.2.4.7.
Proxy Arp Whether or not proxy ARP is enabled or disabled for this
interface. Set using the ip proxy arp command as described
in Section 12.2.4.5.
ICMP ICMP (ping) settings. By default, ICMP messaging is
enabled on a routing interface for both echo-reply and
mask-reply modes. If, for security reasons, ICMP has been
disabled, it can be re-enabled using the ip icmp command as
described in Section 12.2.6.6.
Policy routing Whether or not policy-based routing has been configured on
this interface as described in Section 14.3.13.