Filter
Top Products
Security Configuration Command Set
Configuring Port Web Authentication (PWA)
Matrix NSA Series Configuration Guide 14-55
Table 14-3 show pwa Output Details
Output What It Displays...
PWA Status Whether or not port web authentication is enabled or
disabled. Default state of disabled can be changed using the
set pwa command as described in Section 14.3.6.2.
PWA IP Address IP address of the end station from which PWA will prevent
network access until the user is authenticated. Set using the
set pwa ipaddress command as described in
Section 14.3.6.10.
PWA Protocol Whether PWA protocol is CHAP or PAP. Default setting of
PAP can be changed using the set pwa protocol command as
described in Section 14.3.6.11.
PWA Enhanced
Mode
Whether PWA enhanced mode is enabled or disabled.
Default state of disabled can be changed using the set pwa
enhancedmode command as described in Section 14.3.6.12.
PWA Logo Whether the Enterasys Networks logo will be displayed or
hidden at user login. Default state of enabled (displayed) can
be changed using the set pwa displaylogo command as
described in Section 14.3.6.8.
PWA Guest
Networking Status
Whether PWA guest user status is disabled or enabled with
RADIUS or no authentication. Default state of disabled can
be changed using the set pwa gueststatus command as
described in Section 14.3.6.16.
PWA Guest Name Guest user name for PWA enhanced mode networking.
Default value of “guest” can be changed using the set pwa
guestname command as described in Section 14.3.6.13.
PWA Guest
Password
Guest user’s password. Default value of an empty string can
be changed using the set pwa guestpassword command as
described in Section 14.3.6.15.
PWA Redirect
Time
Time in seconds after login success before the user is
redirected to the PWA home page. Default of 5 can be reset
using the set pwa redirecttime command as described in
Section 14.3.6.9.
Port PWA port designation.