Filter
Top Products
Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
Matrix NSA Series Configuration Guide 14-195
14.3.15.5 set flowlimit action
Use this command to associate an action with a flow limit. This is the action that will occur once
the associated flow limit is reached.
set flowlimit {action1 | action2} [notify] [drop] [disable] [userport | serverport
| aggregateduser | interswitchlink | unspecified]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
action1 | action2 Specifies this configuration as action 1 or 2. Two actions
describing what will occur when a certain flow limit is
reached can be defined per user classification. Action
number must correspond to a flow limit configured using
the set flowlimit limit command as described in
Section 14.3.15.3.
notify (Optional) When flow limit is reached, generates an SNMP
trap notification (if the set flowlimit notification function is
enabled as described in Section 14.3.15.11).
drop (Optional) When flow limit is reached, drops excess flows
and discard packets.
disable (Optional) When flow limit is reached, disables the
interface (if the set flowlimit shutdown function is enabled
as described in Section 14.3.15.10). This will clear all FST
settings on the port.
userport |
serverport |
aggregateduser |
interswitchlink |
unspecified
(Optional) Assigns this action configuration to the user
classification port type:
• user port
• server port
• aggregation port
• inter-switch link
• unspecified port