General Configuration Command Set
Pausing, Clearing and Closing the CLI
2-126 Matrix NSA Series Configuration Guide
2.2.10.3 exit | quit
Use either of these commands to leave a CLI session.
exit
quit
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to exit a CLI session:
NOTE: By default, device timeout occurs after 15 minutes of user inactivity,
automatically closing your CLI session. Use the set logout command as described in
Section 2.2.3.32 to change this default.
When operating in router mode, the exit command jumps to a lower configuration level.
For details on enabling router configuration modes, refer to Section 2.3.3.
Matrix(rw)->exit