Security Configuration Command Set
Configuring Policy-Based Routing
14-172 Matrix NSA Series Configuration Guide
14.3.13.1 show route-map
Use this command to display a configured route map list for policy-based routing.
show route-map id-number
Syntax Description
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to display route map list 101. In this case, the packet source IP addresses
matching ACL lists 2,3,4,8, or 110 will be forwarded to next hop 10.2.1.1, 10.2.2.1 or 10.2.3.1. The
route map list was created using the route-map command (Section 14.3.13.2). The packet source
IP address was then matched to an ACL using the match ip address command (Section 14.3.13.3),
and the packet’s next hops were defined using the set next-hop command (Section 14.3.13.4):
id-number Specifies the ID number for which to display a configured
PBR route map list. Valid values for PBR are 100 - 199.
Matrix>Router1#show route map 101
route-map 101, permit, sequence 1
Match clauses:
ip address 2 3 4 8 110
Set clauses:
next-hop 10.2.1.1 10.2.2.1 10.2.3.1
Policy matches: 0 packets