Filter
Top Products
Matrix Series CLI Overview
1-2 Matrix NSA Series Configuration Guide
1.2 MATRIX SERIES CLI OVERVIEW
Enterasys Networks’ Matrix Series CLI interface allows you to perform a variety of network
management tasks, including the following:
• Assign IP address and subnet mask.
• Select a default gateway.
• Assign a login password to the device for additional security.
• Download a new firmware image.
• Designate which network management workstations receive SNMP traps from the device.
• View device, interface, and RMON statistics.
• Manage configuration files.
• Assign ports to operate in the standard or full duplex mode.
• Control the number of received broadcasts that are switched to the other interfaces.
• Set flow control on a port-by-port basis.
• Set port configurations and port-based VLANs.
• Configure ports to prioritize and assign a VLAN or Class of Service to incoming frames based
on Layer 2, Layer 3, and Layer 4 information.
• Configure the device to operate as a Generic Attribute Registration Protocol (GARP) device to
dynamically create VLANs across a switched network.
• Redirect frames according to a port or VLAN and transmit them on a preselected destination
port.
• Configure Spanning Trees.
• Clear NVRAM.
• Configure interfaces for IP routing.
• Configure RIP, OSPF, DVMRP, IRDP and VRRP routing protocols.
• Configure security methods, including 802.1X. RADIUS, TACACS, CEP, SSHv2, MAC
locking, and DoS attack prevention.
• Configure access lists (ACLs).