![](http://pdfasset.owneriq.net/3/88/3884ec60-08cc-bac4-b176-2f6590d63c88/3884ec60-08cc-bac4-b176-2f6590d63c88-bg478.png)
Routing Protocol Configuration Command Set
Configuring VRRP
13-92 Matrix NSA Series Configuration Guide
13.2.6.2 create
Use this command to create a VRRP session. Each Matrix Series routing module or standalone
device supports up to VRRP sessions. Up to four VRIDs can be associated with an individual
routing interface.
create vlan vlan-id vrid
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command disables the VRRP session:
no create vlan vlan-id vrid
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to create a VRRP session on VLAN 1 with a VRID of 1:
NOTE: This command must be executed to create an instance of VRRP on a routing
interface (VLAN) before any other VRRP settings can be configured.
vlan vlan-id Specifies the number of the VLAN on which to create a
VRRP session. This VLAN must be configured for IP
routing as described in Section 2.3.1.
vrid Specifies a unique Virtual Router ID (VRID) to associate
with the routing interface. The value of vrid can range from
1 to 255.
Matrix>Router1(config)#router vrrp
Matrix>Router1(config-router)#create vlan 1 1