Policy Classification Configuration Command Set
Configuring Policy Profiles
Matrix NSA Series Configuration Guide 8-7
Command Defaults
If optional parameters are not specified, none will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create a policy profile 1 named “netadmin” with PVID override enabled
for PVID 10, and Class-of-Service override enabled for CoS 5. This profile can use VLAN 10 for
untagged egress:
untagged-vlans
untagged-vlans
(Optional) Specifies that the port to which this policy
profile is applied should be added to the egress list of the
VLANs defined by untagged-vlans. Packets will be
formatted as untagged.
append (Optional) Appends this policy profile setting to settings
previously specified for this policy profile by the
egress-vlans, forbidden-vlans, or untagged-vlans
parameters.
If append is not used, previous VLAN settings are replaced.
clear (Optional) Clears this policy profile setting from settings
previously specified for this policy profile by the
egress-vlans, forbidden-vlans, or untagged-vlans
parameters.
Matrix(rw)->set policy profile 1 name netadmin pvid-status enable pvid 10
cos-status enable cos 5 untagged-vlans 10