SNMP Configuration Command Set
Configuring SNMP Target Addresses
5-50 Matrix NSA Series Configuration Guide
Command Defaults
• If not specified, udpport will be set to 162.
• If not specified, mask will be set to 255.255.255.255
• If not specified, timeout will be set to 1500.
• If not specified, number of retries will be set to 3.
• If taglist is not specified, none will be set.
• If not specified, storage type will be nonvolatile.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to configure a trap notification called “TrapSink.” This trap notification
will be sent to the workstation 192.168.190.80 (which is target address “tr”). It will use security and
authorization criteria contained in a target parameters entry called “v2cExampleParams”. For more
information on configuring a basic SNMP trap, refer to Section 5.3.8:
Matrix(rw)->set snmp targetaddr tr 192.168.190.80 param v2cExampleParams
taglist TrapSink