Filter
Top Products
Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3-50 Matrix NSA Series Configuration Guide
3.2.4.17 set lldp port tx-tlv
Use this command to select the optional LLDP and LLDP-MED TLVs to be transmitted in
LLDPDUs by the specified port or ports. Use the show lldp port local-info command to display the
values of these TLVs for the port.
set lldp port tx-tlv {[all] | [port-desc] [sys-name] [sys-desc] [sys-cap]
[mgmt-addr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr]
[max-frame] [med-cap] [med-pol] [med-loc] [med-poe]} port-string
Syntax Description
all Add all optional TLVs to transmitted LLDPDUs.
port-desc Port Description optional basic LLDP TLV. Value sent is
ifDescr object defined in RFC 2863.
sys-name System Name optional basic LLDP TLV. Value sent is the
administratively assigned name for the system.
sys-desc System Description optional basic LLDP TLV. Value sent
is sysDescr object defined in RFC 3418.
sys-cap System Capabilities optional basic LLDP TLV. For a
network connectivity device, value sent can be bridge
and/or router.
mgmt-addr Management Address optional basic LLDP TLV. Value
sent is IPv4 address of host interface.
vlan-id Port VLAN ID IEEE 802.1 Extensions TLV. Value sent is
port VLAN ID (PVID).
stp Spanning Tree information defined by Protocol Identity
IEEE 802.1 Extensions TLV. If STP is enabled on the
port, value sent includes version of protocol being used.
lacp LACP information defined by Protocol Identity IEEE
802.1 Extensions TLV. If LACP is enabled on the port,
value sent includes version of protocol being used.
gvrp GVRP information defined by Protocol Identity IEEE
802.1 Extensions TLV. If LACP is enabled on the port,
value sent includes version of protocol being used.