Filter
Top Products
Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3-38 Matrix NSA Series Configuration Guide
3.2.4.7 show lldp port remote-info
Use this command to display the remote system information stored for a remote device connected
to a local port. You can use this information to detect misconfigurations or incompatibilities
between the local port and the attached endpoint device (remote port).
show lldp port remote-info [port-string]
Syntax Description
Command Defaults
If port-string is not specified, remote system information will be displayed for all
ports.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the remote system information stored for port ge.3.1. The
remote system information was received from an IP phone, which is an LLDP-MED-enabled
device. Table 3-5 describes the output fields that are unique to the remote system information
displayed for a MED-enabled device.
port-string (Optional) Displays remote system information for one or
a range of ports.
Matrix(ro)->show lldp port remote-info ge.3.1
Local Port : ge.3.1 Remote Port Id : 00-09-6e-0e-14-3d
---------------------
Mgmt Addr : 0.0.0.0
Chassis ID : 0.0.0.0
Device Type : Communication Device Endpoint (class III)
Sys Name : AVE0E143D
Sys Cap Supported/Enabled : bridge,telephone/bridge
Auto-Neg Supported/Enabled : yes/yes
Auto-Neg Advertised : 10BASE-T, 10BASE-TFD
: 100BASE-TX, 100BASE-TXFD
: pause, Spause
Operational Speed/Duplex/Type : 100/full/TX