Routing Protocol Configuration Command Set
Configuring OSPF
Matrix NSA Series Configuration Guide 13-39
13.2.3.6 timers spf
Use this command to change OSPF timer values to fine-tune the OSPF network.
timers spf spf-delay spf-hold
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command restores the default timer values (5 seconds for
delay and 10 seconds for holdtime):
no timers spf
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to set spf delay time to 7 seconds and hold time to 3:
spf-delay Specifies the delay, in seconds, between the receipt of an
update and the SPF execution. Valid values are 0 to
4294967295.
spf-hold Specifies the minimum amount of time, in seconds, between
two consecutive OSPF calculations. Valid values are 0 to
4294967295. A value of 0 means that two consecutive OSPF
calculations are performed one immediately after the other.
Matrix>Router1(config)#ospf 1
Matrix>Router1(config-router)#timers spf 7 3