Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
14-200 Matrix NSA Series Configuration Guide
14.3.15.8 set flowlimit port
Use this command to:
• enable or disable flow limiting on one or more port(s),
• assign a flow limiting user classification to one or more port(s). Once a classification is assigned,
these ports will be subject to the flow limit configured (with the set flowlimit limit command as
described in Section 14.3.15.3) and the action configured (with the set flowlimit action
command as described in Section 14.3.15.5).
• Enable an interface previously disabled by a flow limiting action.
set flowlimit port {enable | disable} | class {userport | serverport |
aggregateduser | interswitchlink | unspecified} | status {operational}
[port-string]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
If port-string is not specified, settings will apply to all ports.
enable | disable Enables or disables flow limiting on specified ports.
class userport |
serverport |
aggregateduser |
interswitchlink |
unspecified
Assigns a user classification type to the port(s) as:
• user port
• server port
• aggregation port
• interswitch link
• unspecified port
status operational Enables an interface previously disabled by a flow limiting
action.
port-string (Optional) Specifies port(s) on which to configure flow
limiting parameters.