Filter
Top Products
Configuring LACP
Configuring Link Aggregation
Matrix NSA Series Configuration Guide 4-107
4.5.4.7 set lacp static
Use this command to assign one or more underlying physical ports to a Link Aggregation Group
(LAG).
set lacp static lagportstring [key] port-string
Syntax Description
Command Defaults
If not specified, a key will be assigned according to the specified aggregator. For
example a key of 4 would be assigned to lag.0.4.
Command Type
Switch command.
Command Mode
Read-Write.
NOTES: At least two ports need to be assigned to a LAG port for a Link Aggregation
Group to form and attach to the specified LAG port.
The same usage considerations for dynamic LAGs discussed in Section 4.5.3 apply to
statically created LAGs.
Static LAG configuration should be performed by personnel who are knowledgeable
about Link Aggregation. Misconfiguration can result in LAGs not being formed, or in
ports attaching to the wrong LAG port, affecting proper network operation.
lagportstring Specifies the LAG aggregator port to which new ports
will be assigned.
key (Optional) Specifies the new member port and LAG port
aggregator admin key value. Only ports with matching
keys are allowed to aggregate. Valid values are 0 - 65535.
NOTE: This key value must be unique. If ports
other than the desired underlying physical ports
share the same admin key value, aggregation
will fail or undesired aggregations will form.
port-string Specifies the member port(s) to add to the LAG. For a
detailed description of possible port-string values, refer
to Section 4.1.1.