General Configuration Command Set
Downloading a New Firmware Image
2-96 Matrix NSA Series Configuration Guide
3. Type 2. The following baud rate selection screen displays:
4. Type 8 to set the device baud rate to 115200. The following message displays:
5. Set the terminal baud rate to 115200 and press ENTER.
6. Type download to start the ZMODEM receive process.
7. Send the image file using the ZMODEM protocol from your terminal application. (This
procedure will vary depending on your application.) When the ZMODEM download is finished,
the following message displays:
8. Set the device baud rate back to 9600.
9. Set the terminal baud rate back to 9600 and press ENTER.
10.Type setboot filename to set the device to boot to the new firmware image. In this example, the
downloaded image file is named “myimage.” The following message displays:
1 - 1200
2 - 2400
3 - 4800
4 - 9600
5 - 19200
6 - 38400
7 - 57600
8 - 115200
0 - no change
Setting baud rate to 115200, you must change your terminal baud rate.
[System Image Loader
]: download
Preparing to receive file...
Writing file...
Download successful.
[System Image Loader
]:
[System Image Loader]: setboot myimage
Image boot file set to myimage
[System Image Loader
]: