Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix NSA Series Configuration Guide 6-79
6.2.1.66 set spantree backuproot
Use this command to enable or disable the Spanning Tree backup root function. Enabled by default
on bridge(s) directly connected to the root bridge, this prevents stale Spanning Tree information
from circulating in the event the root bridge is lost. If this happens, the backup root will dynamically
lower its bridge priority so that it will be selected as the new root over the lost root bridge.
set spantree backuproot sid {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the backup root function on SID 2:
sid Specifies the Spanning Tree on which to enable or disable
the backup root function. Valid values are 0 - 4094.
enable | disable Enables or disables the backup root function.
Matrix(rw)->set spantree backuproot 2 enable