IP Configuration Command Set
Reviewing and Configuring the ARP Table
12-20 Matrix NSA Series Configuration Guide
12.2.4.1 show ip arp
Use this command to display entries in the ARP (Address Resolution Protocol) table. ARP converts
an IP address into a physical address.
show ip arp [ip-address] [vlan vlan-id] [output-modifier]
Syntax Description
Configuration Mode
Any router mode.
Command Defaults
If no parameters are specified, all entries in the ARP cache will be displayed.
ip-address (Optional) Displays ARP entries related to a specific IP
address.
vlan vlan-id (Optional) Displays only ARP entries learned through a
specific VLAN interface. This VLAN must be configured
for IP routing as described in Section 2.3.1.
output-modifier (Optional) Displays ARP entries within a specific range.
Options are:
• | begin ip-address — Displays only ARP entries that
begin with the specified IP address.
• | exclude ip-address — Excludes ARP entries
matching the specified IP address.
• | include ip-address — Includes ARP entries
matching the specified IP address.