Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
Matrix NSA Series Configuration Guide 4-67
4.3.8.1 show port trap
Use this command to display whether the port is enabled for generating an SNMP trap message if
its link state changes.
show port trap [port-string]
Syntax Description
Command Defaults
If port-string is not specified, the trap status for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to display link trap status for fe.3.1 through 4:
port-string (Optional) Displays link trap status for specific port(s). For
a detailed description of possible port-string values, refer to
Section 4.1.1.
Matrix(rw)->show port trap fe.3.1-4
Link traps enabled on port fe.3.1.
Link traps enabled on port fe.3.2.
Link traps enabled on port fe.3.3.
Link traps enabled on port fe.3.4.