![](http://pdfasset.owneriq.net/3/88/3884ec60-08cc-bac4-b176-2f6590d63c88/3884ec60-08cc-bac4-b176-2f6590d63c88-bg221.png)
Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
Matrix NSA Series Configuration Guide 6-117
6.2.2.25 set spantree adminpoint
Use this command to set the administrative point-to-point status of the LAN segment attached to a
Spanning Tree port.
set spantree adminpoint port-string {true | false | auto}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the LAN attached to fe.1.3 as a point-to-point segment:
port-string Specifies the port on which to set point-to-point protocol
status. For a detailed description of possible port-string
values, refer to Section 4.1.1.
true | false | auto Specifies the point-to-point status of the LAN attached to
the specified port.
• true forces the port to be considered point-to-point.
• false forces the port to be considered non point-to-point.
• auto (the default setting) allows the firmware to
determine the port’s point-to-point status.
Matrix(rw)->set spantree adminpoint fe.1.3 true