![](http://pdfasset.owneriq.net/3/88/3884ec60-08cc-bac4-b176-2f6590d63c88/3884ec60-08cc-bac4-b176-2f6590d63c88-bg4f9.png)
Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
Matrix NSA Series Configuration Guide 14-113
14.3.8.11 set cep detection-id protocol
Use this command to specify an IP protocol type for H.323, Siemens, or SIP convergence end points
detection. If an IP address is not set for a phone detection group as described in Section 14.3.8.10,
this will configure detection on UDP and/or TCP ports using a port range defined with the set cep
detection-id porthigh | portlow command as described in Section 14.3.8.12.
set cep detection-id id protocol {tcp | udp | both | none}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable both TCP and UDP convergence end points detection for CEP
detection group 1
:
NOTE: This command applies only to Siemens, H.323, and SIP phone detection. Cisco
detection uses CiscoDP as its discovery method.
id Specifies a CEP configuration group ID. This group must
be created and enabled using the set cep detection-id
command as described in Section 14.3.8.8. Valid values are
1 - 2147483647.
tcp | udp | both |
none
Sets the CEP IP protocol type to be used for detection as:
• TCP
• UDP
• Both UDP and TCP
• None
Matrix>set cep detection-id 1 protocol both