![](http://pdfasset.owneriq.net/3/88/3884ec60-08cc-bac4-b176-2f6590d63c88/3884ec60-08cc-bac4-b176-2f6590d63c88-bg3a1.png)
IP Configuration Command Set
Performing a Basic Router Configuration
Matrix NSA Series Configuration Guide 12-17
12.2.3 Performing a Basic Router Configuration
12.2.3.1 Using Router-Only Config Files
Although the Matrix Series’ single configuration interface provides one set of commands to
perform both switch and router configuration, it is still possible to use router-only commands to
configure the router. To do so, you need to add router config wrappers to your existing router config
files, as shown in Figure 12-1.
Figure 12-1 Example of a Simple Matrix Series Router Config File
12.2.3.2 Displaying or Writing the Current Config to a File
The Matrix Series’ single configuration interface allows you use the show config command to
display or write the current router configuration to a file. For details, refer to Section 2.2.8.3.
begin router 1
enable
conf t
write file
exit
disable
exit
end router 1