Routing Protocol Configuration Command Set
Configuring OSPF
Matrix NSA Series Configuration Guide 13-69
13.2.3.27 show ip ospf neighbor
Use this command to display the state of communication between an OSPF router and its neighbor
routers.
show ip ospf neighbor [detail] [ip-address] [vlan vlan-id]
Syntax Description
Command Type
Router command.
Command Mode
Any router mode.
Command Defaults
• If detail is not specified, summary information will be displayed.
• If ip-address is not specified, OSPF neighbors will be displayed for all IP
addresses configured for routing.
• If vlan-id is not specified, OSPF neighbors will be displayed for all VLANs
configured for routing.
Example
This example shows how to use the show ospf neighbor command:
detail (Optional) Displays detailed information about the
neighbors, including the area in which they are neighbors,
who the designated router/backup designated router is on the
subnet, if applicable, and the decimal equivalent of the E-bit
value from the hello packet options field.
ip-address (Optional) Displays OSPF neighbors for a specific IP
address.
vlan vlan-id (Optional) Displays OSPF neighbors for a specific VLAN.
This VLAN must be configured for IP routing as described
in Section 2.3.1.
Matrix>Router1#show ip ospf neighbor
ID Pri State Dead-Int Address Interface
182.127.62.1 1 FULL 40 182.127.63.1 vlan1