Filter
Top Products
449
■ Checking the NTP Server Settings by Synchronizing the
System Time
On the [NTP Server] window, press the [Sync Time] button to check if the system time can
be synchronized.
After pressing the [Sync Time] button, follow each action described below according to
the message that is shown.
The messages and their corresponding actions are as follows.
■ Action
None
■ Action
Try the following:
z Check the specified NTP server IP address, host name, or FQDN for mistakes, and correct
them.
z Check the network path between to the NTP server for problems.
z The NTP server may be busy. Wait a short time before trying again to synchronize the system
time. If that does not work, the specified server may not be an NTP server, so try a different
NTP server. The specified NTP server cannot provide a trusted date and time.
z It attempted to acquire the date and time from a higher level NTP server, but failed. Try a
different NTP server or have the network administrator investigate.
z Check that the time is correct.
If the time is incorrect, adjust the date/time, and try again.
z Refer to "4.5.4 Setting the Date/Time" (page 98), adjust the date/time, and try again.
System time has been successfully synchronized.
System time synchronization failed.