Filter
Top Products
478
A.5 Multifeed Detection Conditions
There are three multifeed detection modes: document layer, document length, and both
document layer and length.
To detect multifeeds with document layer, document length, or both document layer and
length, specify [Ultrasonic], [Length], or [Both], in "6.9.19 Multifeed Detection (Layer and
Length)" (page 392).
The following conditions must be satisfied in each of these detection modes.
Detection by Layer
z Set sheets of the same thickness in the ADF paper chute for a series of scans.
z Paper weight: 52 to 127 g/m
2
(14 to 34 lb) (45 to 110 kg/ream) (0.06 to 0.15 mm)
z Punched holes are not allowed within 25 mm (0.98 in.) either side of the center of
paper.(*)
z Do not glue on any other paper within 25 mm (0.98 in.) either side of the center of
paper.(*)
(*): Refer to Figure 1.
Detection by Length
z Set sheets of the same length in the ADF paper chute for a series of scans.
z Document length deviation: 1% or less
z Punched holes are not allowed within 25 mm (0.98 in.) either side of the center of
paper.(*)
(*): Refer to Figure 1.
Detection by both Layer and Length
z Set sheets of the same thickness and length in the ADF paper chute for a series of
scans.
z Document thickness: 52 to 127 g/m
2
(45 to 110 kg for 1,000 sheets) (0.065 to 0.15
mm)
z Document length deviation: 1% or less
z Punched holes are not allowed within 25 mm (0.98 in.) either side of the center of
paper.(*)
z Do not glue on any other paper within 25 mm (0.98 in.) either side of the center of
paper.(*)
(*): Refer to Figure 1.