Filter
Top Products
FC-210/310 TROUBLESHOOTING 4 - 4 February 2002 © TOSHIBA TEC
4.1.2 Paper feeding jam
[E11] Paper misfeed from the ADU
Is any paper remaining in the paper feed area inside the ADU?
Remove the paper.
Is the connector J104 on the LGC board disconnected?
Is the harness between the LGC board and the ADU drawer connector open-circuited?
Reconnect the connector. Replace the harness.
1. Replace the LGC board.
2. Replace the ADU.
[E12] Paper misfeed from the bypass
Is any paper set in the bypass tray?
Does the paper remain within the specified paper weight and stack height ?
Is there any foreign matter such as scrap of paper in the paper
transport path from the bypass feed section up to the registration
rollers?
Eliminate the foreign matter.
Check if the bypass pick-up roller, bypass feed roller or separation
roller is not deteriorated. Replace them if necessary.
NO
Keep to the paper weight and stack height described in the specification.
Is the bypass paper sensor functioning properly? (Does the actuator return normally?)
1. In the test mode (03) check if the bypass paper sensor is functioning.
2. Reconnect the bypass paper sensor connector.
Repair the actuator if it has come off.
YES
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO