Toshiba FC-210 Copier User Manual


 
FC-210/310 TROUBLESHOOTING 4 - 16 February 2002 © TOSHIBA TEC
[EA8] Saddle stitcher stapling jam
Is there any paper remaining on the transport path in the finisher, saddle stitcher section or copier, or
on the stapling tray?
YES
Remove the paper.
NO
Is the jam cleared by taking off the staple cartridge from the saddle stitcher and removing the
staples stuck in the stapling unit?
YES
End
NO
Is the connector J8 on the saddle stitcher controller PC board disconnected?
Is the harness connecting the saddle stitcher controller PC board and stitcher home position switch
(rear: MS5S, front: MS7S) open-circuited?
YES
Connect the connector securely. Replace the harness.
NO
Are the stitcher home position switches working properly?
NO
Replace the stapler unit.
YES
Replace the saddle stitcher controller PC board.
[EA6] Finisher early arrival jam
Is there any paper remaining on the transport path in the finisher or copier?
YES
Remove the paper.
NO
Is the connector J17 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and inlet sensor (PI1) open-circuited?
YES
Connect the connector securely. Replace the harness.
NO
Is the inlet sensor functioning properly? (Does the actuator return normally?)
NO
1. Connect the connector of the inlet sensor securely.
2. Attach the actuator if it has come off.
3. Replace the inlet sensor.
YES
Replace the finisher controller PC board.