Filter
Top Products
FC-210/310 TROUBLESHOOTING 4 - 12 February 2002 © TOSHIBA TEC
4.1.7 Paper jam in the finisher
[E9F] Punching jam
Is there any paper remaining on the transport path in the finisher or copier?
Remove the paper.
Is either of the connectors J1 or J3 on the punch driver PC board disconnected?
Is the harness connecting the punch driver PC board and punch home position sensor
(PI3P) open-circuited?
Connect the connector securely. Replace the harness.
Is the punch home position sensor working properly?
1. Connect the connector of the punch home position sensor securely.
2. Replace the punch home position sensor.
Replace the punch driver PC board.
[EA1] Finisher paper transport delay jam
Is there any paper remaining on the transport path in the finisher or copier?
YES
Remove the paper.
NO
Is the connector J17 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and inlet sensor (PI1) open-circuited?
YES
Connect the connector securely. Replace the harness.
NO
Is the inlet sensor functioning properly? (Does the actuator return normally?)
NO
1. Connect the connector of the inlet sensor securely.
2. Attach the actuator if it has come off.
3. Replace the inlet sensor.
YES
Replace the finisher controller PC board.
YES
NO
YES
NO
NO
YES