Filter
Top Products
February 2002 © TOSHIBA TEC 2 - 21 FC-210/310 ADJUSTMENT
(g) Adjustment of image trailing edge margin
1. While pressing the digital keys [0] and [5] simultaneously, turn the power ON. ৎ (Adjustment mode)
2. Place Test Chart No. TCC-1 on the original glass (with the arrow positioned at the left rear side).
3. Press [ENERGY SAVER] ৎ [START] to make a copy in the mode of A4/LT, 100%, full color and text/
photo.
4. Measure the margin width E on the bottom edge of the copy image with a ruler.
5. Check if the margin width E is within a range of 2.5±0.5 mm or not.
6. If it is not, change values using the following procedure, and repeat step 3. to 5. above.
<Procedure> (Adjustment mode) ৎ (Enter code [428] with digital keys) ৎ [START]
ৎ (Enter a value (acceptable values : 0 to 255) with digital keys)
ৎ [SET] or [INTERRUPT] (Stored in memory)
* The larger the adjustment value, the smaller the margin width on the bottom edge becomes (0.042 mm/step).