Filter
Top Products
February 2002 © TOSHIBA TEC 2 - 29 FC-210/310 ADJUSTMENT
Code Color mode Original mode Contents
737 Full color
738
739
740
741
742 Black
743
744
745
746
Text/photo
Te x t
Printed image
Photo
Map
Text/photo
Text
Printed image
Photo
Map
2.6.7 Sharpness adjustment
If you want to make copy images look softer or sharper, perform the following adjustment. The adjustment
can be made for each of the color modes and original modes independently.
• The larger the value, the sharper the image
becomes; while the smaller the value, the softer the
image becomes.
• The smaller the value, the less moire tends to
appear.
• The acceptable values are 0 to 31.
The center value is 16.
However, 0 is equivalent to the center value.
Note: You have to make adjustment by compromising
between moire and sharpness.
Make a test copy and compare the image obtained with the current settings; if necessary, make adjust-
ment using the following procedure.
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Enter the code of required mode (color mode or original mode) with digital keys and press the [START]
key.
(3) Enter an adjustment value with digital keys.
(To correct an entered value, press the [CLEAR] key.)
(4) Press the [SET] or [INTERRUPT] key to store the value in memory. ৎ The copier goes back to the
standby state.
(5) Press the [ENERGY SAVER] key and then press the [START] key to make a test copy.
(6) If the desired image sharpness has not been attained, repeat step (2) to (5).