Filter
Top Products
February 2002 © TOSHIBA TEC 4 - 17 FC-210/310 TROUBLESHOOTING
[EA9] Saddle stitcher door opened during printing
Is there any paper remaining on the transport path in the finisher, saddle stitcher section or copier?
YES
Remove the paper.
NO
Is the saddle stitcher door closed?
NO
Close the door.
YES
Is either of the connectors J10 or J11 on saddle stitcher controller PC board disconnected?
Is any of the harnesses connecting between the saddle stitcher controller PC board and cover
opening sensors (PI2S: front door opening/closing sensor, PI3S: delivery cover sensor, PI9S: inlet
cover sensor) open-circuited?
YES
Connect the connector securely. Replace the harness.
NO
Are the cover opening sensors working properly?
NO
1. Connect the connectors of the cover opening sensors securely.
2. Replace the cover opening sensors.
YES
Replace the saddle stitcher controller PC board.
[EAA] Paper remaining at the saddle stitcher at power ON
Is there any paper remaining on the transport path in the finisher or saddle stitcher section?
YES
Remove the paper.
NO
Is any of the connectors J10, J13 and J9 on the saddle stitcher controller PC board disconnected?
Is any of the harnesses connecting between the saddle stitcher controller PC board and sensors
(No.1 paper sensor (PI18S), No.2 paper sensor (PI19S), No.3 paper sensor (PI20S), vertical path
paper sensor (PI17S) and delivery sensor (PI11S)) open-circuited?
YES
Connect the connector securely. Replace the harness.
NO
Are the No.1 paper sensor, No.2 paper sensor, No.3 paper sensor, vertical path paper sensor and
delivery sensor functioning properly? (Do the actuators return normally?)
NO
1. Connect the connectors of the sensors securely.
2. Attach the actuators if they have come off.
3. Replace the sensors.
YES
Replace the saddle stitcher controller PC board.