Filter
Top Products
February 2002 © TOSHIBA TEC 2 - 37 FC-210/310 ADJUSTMENT
2.9.2 Lens unit
(a) Replacing the lens unit
· Since the lens unit was precisely adjusted at the factory, it must not be readjusted in the field or some of
its components must not be replaced. If necessary, the lens unit should be replaced as a unit.
· While replacing with a new lens unit, never loosen or remove the six screws indicated with arrows below.
They are locked with adhesive.
· Use sufficient care when handling the lens unit. Never hold the precision-adjusted area of the lens unit.
Adjusted area