Filter
Top Products
FC-210/310 ADJUSTMENT 2 - 40 February 2002 © TOSHIBA TEC
2.11 Key Copy Counter (MU-8, MU-10)
To make a key copy counter available, the following 2 components must be installed to the copier.
Counter socket
MU-10
Key copy
counter
MU-8
<Installation procedure>
(1) Remove the rear cover.
(2) Remove the feed side upper cover, and cut open
the window for the key copy counter.
(3) Pull out the harness connector from the hole
of the machine frame, and cut the short harness
of the connector. (Treat the cut harness properly
to avoid it causing a short-circuit with the
machine frame.) Then, disconnect the dummy
connector.
Dummy
connector
Socket attachment screw holes
Harness
connector