Filter
Top Products
FC-210/310 TROUBLESHOOTING 4 - 10 February 2002 © TOSHIBA TEC
4.1.6 Original jam in the RADF
[E71] Original not reaching the aligning sensor
[E72] Original not reaching the exit sensor
[E73] Original not passing the exit sensor
[Two or more originals are fed simultaneously.]
Have too many originals been placed?
Reset the originals, following the specification.
Are the original sheets curled or folded too much?
Flatten and reset the originals.
Are different-size originals placed together?
Set only one-size originals.
Is the gap between the aligning plate and the feed roller too large?
Adjust the gap.
Is the separation pad stained?
Clean the separation pad.
YES
NO
YES
NO
YES
NO
YES
NO
YES