Filter
Top Products
February 2002 © TOSHIBA TEC 4 - 27 FC-210/310 TROUBLESHOOTING
[C35] Transfer belt unit contact/release function abnormal
Reduce the mechanical load by adjusting the drive system. Remove any foreign matter.
Is the harness between the LGC board and the transfer/transport unit drawer connector, or the
harness inside the transfer/transport unit open-circuited?
Is the transfer belt contact/release drive motor connector, LGC board connector J115 or J102,
transfer belt home position switch connector, or transfer belt limit switch connector discon-
nected?
Is the transfer belt home position switch or the transfer belt limit switch defectively installed?
1. Replace the harness. Reconnect the connector.
2. Reinstall the transfer belt home position switch or the transfer belt limit switch
securely.
1. Replace the transfer belt home position switch and the transfer belt limit switch.
2. Replace the transfer belt contact/release drive motor.
3. Replace the LGC board.
YES
NO
[C38] Auto-toner error (K)
[C39] Auto-toner error (C)
[C3A] Auto-toner error (M)
[C3B] Auto-toner error (Y)
Is the harness between the LGC board and the EPU drawer connector open-circuited?
Is any harness inside the EPU or the auto-toner sensor harness open-circuited?
Is the auto-toner sensor connector or the connector J120 on the LGC board disconnected?
Reconnect the connector. Replace the harness.
1. Replace the auto-toner sensor.
2. Replace the LGC board.
YES
NO