Filter
Top Products
February 2002 © TOSHIBA TEC 2 - 25 FC-210/310 ADJUSTMENT
2.6.2 Density adjustment
The center density and the density variation controlled by density adjustment keys can be adjusted as
follows.
Original mode
Text/photo Text
Printed
Photo Map
Items to be adjusted Remarks
image
550 551 552 553 554
560 561 562 563 564
570 571 572 573 574
580 581 582 583 584
555 556 557 558 559
565 566 567 568 569
575 576 577 578 579
585 586 587 588 589
Full color
The larger the value, the
darker the image becomes.
The larger the value, the darker
the “dark” side becomes.
The larger the value, the lighter
the “light” side becomes.
The larger the value, the
darker the image becomes.
The larger the value, the
darker the image becomes.
The larger the value, the darker
the “dark” side becomes.
The larger the value, the lighter
the “light” side becomes.
The larger the value, the
darker the image becomes.
Manual density
center value
Manual density
“dark” step value
Manual density
“light” step value
Automatic density
Manual density
center value
Manual density
“dark” step value
Manual density
“light” step value
Automatic density
Black
Make a test copy and compare the image obtained with the current settings; if necessary, make adjust-
ment using the following procedure.
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Enter the code of required mode (color mode, original mode, item to be adjusted) with digital keys and
press the [START] key.
(3) Enter an adjustment value with digital keys (acceptable values: 0 to 255).
(To correct an entered value, press the [CLEAR] key.)
(4) Press the [SET] or [INTERRUPT] key to store the value. ৎ The copier goes back to the standby
state.
(5) Press the [ENERGY SAVER] key and then press the [START] key to make a test copy.
(6) If the desired image density has not been attained, repeat step (2) to (5).
Color
mode