Filter
Top Products
February 2002 © TOSHIBA TEC 4 - 49 FC-210/310 TROUBLESHOOTING
[CD6] Saddle stitcher/microswitch abnormal
[Procedure 1]
Is the switch actuator for the inlet door working properly?
NO
Correct the mechanism.
YES
Is the inlet cover switch (MS1S) working normally?
NO
Replace the switch.
YES
Is the voltage of J10-8 on the saddle stitcher controller PC board 5V when the inlet door is open?
YES
The inlet cover sensor (PI9S) is broken. Replace it.
NO
Is the voltage between J19-2 (+) and J19-1 (-) on the finisher controller PC board 24 V?
NO
Replace the finisher controller PC board.
YES
Check and correct the wiring between J19 on the finisher controller PC board and J1 on the saddle
stitcher controller PC board. If there is no problem, replace the saddle stitcher controller PC board.