Filter
Top Products
FC-210/310 TROUBLESHOOTING 4 - 48 February 2002 © TOSHIBA TEC
[Procedure 2]
Is the connector of paper pushing plate home position sensor (PI14S) connected to the connector
on the saddle stitcher controller PC board?
NO
Connect the two connectors.
YES
Is the wiring between the sensor and the saddle stitcher correct?
NO
Correct the wiring.
YES
Is 5V DC being supplied from J9-10 on the saddle stitcher controller PC board?
NO
Replace the saddle stitcher controller PC board.
YES
Is J9-11 on the saddle stitcher controller PC board properly connected to the ground?
NO
Replace the saddle stitcher controller PC board.
YES
End
[Procedure 3]
Is the connector of paper pushing plate top position sensor (PI15S) connected to the connector on
the saddle stitcher controller PC board?
NO
Connect the two connectors.
YES
Is the wiring between the sensor and the saddle stitcher correct?
NO
Correct the wiring.
YES
Is 5V DC being supplied from J9-13 on the saddle stitcher controller PC board?
NO
Replace the saddle stitcher controller PC board.
YES
Is J9-14 on the saddle stitcher controller PC board properly connected to the ground?
NO
Replace the saddle stitcher controller PC board.
YES
End